Aim M10 VDO Pressure Sensor 0-10 Bar

£100

The M10 VDO Pressure Sensor (0-10 Bar), is screwed to the engine. Two connectors sample GND and pressure...

The M10 VDO Pressure Sensor (0-10 Bar), is screwed to the engine. Two connectors sample GND and pressure signals monitoring oil or fuel pressure levels.       

This sensor fits the measurement of pressure of liquids like oil and fuel.

The VDO 0-5 bar/0-10 bar sensor is made of a cylinder with M10*1 thread, that has to be screwed to the engine. The two connectors that sample GND and pressure signals.

If the engine thread is bigger than the cylinder thread, Aim suggests you use joints. Aim recommends to tightly screw the sensor to the engine so that vibrations do not loosen it.

Note:

Do not use it to measure brake pressure. It needs a careful installation. This is why AiM suggests to address to a specialised workshop.

Aim Technologies is committed to supplying, professional engineer’s quality Motorsport products. These small, lightweight but well-engineered pressure sensors are among the best in the market place today.